![]() After the device-specific driver is installed, Windows 10 will select that driver instead of the standard USB audio 2.0 driver when you first connect the device. If the device is not yet connected, first install the device-specific driver, such as by using the appropriate installer. For more information about how to do this, see update drivers in Windows 10. ![]() If the device-specific driver is distributed through Windows Update, you can manually update the driver by using Device Manager. To resolve this issue, install update 4022716. To fix this issue, use one of the following methods. This issue also causes Windows 10 Version 1703 to postpone the search for other compatible drivers through Windows Update that typically occurs immediately after you install a new device. (The left-side search illustration below is in Windows 11, and the right-side is Windows 10.) Uninstall the driver of USB Host Controller. Type and search Device Manager in the Windows search bar, then click Open. Disconnect all USB devices from the computer. Therefore, the system assumes that a compatible, nongeneric driver is installed for the device even though the driver is generic. Reinstall USB Host Controller driver in Device Manager. This issue occurs because the USB audio 2.0 driver (usbaudio2.sys) isn't classified as a generic driver in Windows 10 Version 1703. When you connect a USB audio device to a Windows 10 Version 1703-based computer the first time, the operating system detects the device but loads the standard USB audio 2.0 driver (usbaudio2.sys) instead of the specific device driver. Back then, I had no audio issues at all.This article helps to fix an issue in which Windows 10 doesn't install specific drivers for USB audio devices on the first connection.Īpplies to: Windows 10, version 1703 Original KB number: 4021854 Symptom I had a Windows 10 installation on this Mac working just find a few months ago, and then I removed the installation with Boot Camp Assistant in macOS once I had no need for Windows. This version of the driver has the same issue for the headphone jack only.Ĭould anyone please suggest to me any other avenues I can try? The name of the driver that Windows selected is the same, however the version number is 6.6001.4.2. I have also installed the updated version of this driver from Cirrus Logic's website to see whether this may fix the issue. The audio driver that came with my Boot Camp Support download which appears to be supported for my model of iMac is "Cirrus Logic CS8409 (AB 16)", version 6.6001.3.38. Neither replacing the audio driver with the Windows default "High Definition Audio Device" driver, nor selecting the manufacturers driver from the Boot Camp Support download from within Boot Camp Assistant on macOS for my 2017 iMac seems to work. I have attempted to reinstall the audio driver numerous time to remedy this issue. Audio sounds just fine through the iMac's normal speakers. The sound issue isn't apparent when the headphones are unplugged. The volume controls don't change the loudness of the tone. It's as though any sound that is meant to come from the audio output is a consistent high-pitch tone. For me, it instead emits a high-pitch tone for a few seconds, and then it ceases. For example, if I have my speakers plugged into my iMac via a 3.5mm audio jack, and change the volume of the headphones output from the taskbar, Windows should emit a pleasant chord sound to test the audio volume. Whenever I attempt to use audio through my headphones port, I hear a shrill high-pitch tone. The installation of Windows performed successfully, and the Boot Camp drivers were installed correctly too - apart from the sound driver it seems. I have macOS Big Sur 11.5 installed at the time of the Boot Camp installation of Windows. I have recently reinstalled Windows 10 Home on my 2017 iMac 27". High pitch tone when plugged into 3.5mm headphone jack - Windows 10 - iMac 2017 Hey team.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |